
v15.0 [Aug 17, 2011]
3D View
-The application would quit attempting to preview a Dipswitch 3D package for a PCB symbol which had no pads.
Add Net
-Adding a new net to a pin on schematic sheet in a Project could cause the application to quit.
Auto Correct Track
-Portions of the original track could be left behind as the corrected track is inserted.
Edit Mitre
-When starting to mitre a corner using double-click the edited segments were drawn incorrectly making it difficult
to see what you were editing.
Integrity Check
-After renaming components in the schematic, applying those changes to the PCB could cause incorrect changes to be made to components.
-In some circumstances, the presence of very similar components in the Schematic could cause Integrity Check to repeatedly swap components in and out of the PCB.
Plotting
-The Drill Ident setup dialog would mistakenly report duplicate entries when the rounding that occurs due to unit precision resulted in more than one row in the table showing the same hole size.
Pour Copper
-Pouring was using the pad-to-copper spacing rather than the thermal isolation gap specified in the design rules for
pads/vias on the same net as the copper.
Properties
-Changes to the ‘Show Connections’ checkbox on the Net properties tab were not being saved.
Save To Library
-Symbols saved to the library using the Save To Library dialog could be incomplete.
Sketch Track
-The track pattern produced by Sketch Track was sometimes incorrect, with many small segments twisted over each other.
Symbol Edit
-Editing a PCB symbol would not display the pads if no technology file was used.
Technology
-Changes to the ‘Show Connections’ setting on the Nets page of the Design Technology dialog were not being saved.
TraceRouter
-The TraceRouter was not enabled unless the ‘Easy-Router’ optional feature was installed, whereas it should also be available if ProRouter was installed.
-Some designs with large Board spacings would not route.
-Attempting to route a design containing a Net Class that did not have a Via Style assigned to it would cause the application to quit.
Upload your own photos so you can use them to decorate your CD's or DVD's.